|
|
|
New-Tech™ Down Draft Table Pictures
(3 of 12)
|
 
|
 |
- Down Draft Table Picture DDT-03
- Separated View of a Custom Down Draft Table Assembly shown in picture DDT-01 and DDT-02.
- These two separate tables were installed back to back to make an assembly that was accessed by the users from each side.
- This picture shows the adjustable dampers used to balance the airflow across the work surface.
- This picture shows the drain that in located on each end of the exhaust chamber to allow for drainage of any liquids.
- This table is constructed of cold rolled steel with a baked on epoxy powder coated finish.
- The work surface is Stainless Steel
perforated material with 1/4" dia. holes on 3/8" staggered centers.
|
|
